Status
Not open for further replies.

Bob Read

Member
Dec 9, 2000
393
10
263
I hope someone can help me. Approximately a year or so ago there was a discussion about the method used to "cut in" Titanic's name into the plating. There was a gentleman whose name I can't remember who actually worked in the H&W shipyards who described how this was done. This man was a wealth of technical information on riveting practices, etc but for the life of me I can't remember his name. Can anybody point me to this thread? I tried using the search engine without much luck so I'll pose it to the human brains out there that have better and more specific memories.

Regards,
Bob Read
 
Status
Not open for further replies.

Similar threads

Similar threads